Separating cuts for fee

If the purchase of a Diamond WireTec diamond wire saw does not make sense for you, we are also happy to accept your job order. We cut your workpieces according to your specifications at reasonable prices. Simply send us your inquiry - preferably with a sample - so that we can provide you with an offer.

To the contact form

Hardened steel ball

This is a hardened steel ball with a diameter of 3 mm, such as those used in ball bearings. After the hardening process, the hardness test can be carried out more easily on the separated ball.

Silicon chip

This is a silicon chip that was separated with a 0.08 mm diamond wire. The voltage was applied horizontally. The cut was terminated by means of an adjusted end stop.

Carbide insert

This is a carbide insert which may be defective during manufacture. This can be checked after one or more fine cut-offs.

Zirconium rods

This is a round rod made of zirconium, which is used for processing in dental laboratories, for example.

Coin

This is a coin (10 cents) that has been cut into three slices using two fine saw cuts. It should be noted that the coin must also be clamped (held). In this case with special wax on a ceramic disk.