This special magnet, consisting of many different materials with different properties, should be separated to observe the microstructure.
This is a vehicle tire consisting of rubber compounds, nylon and steel, etc. The exact embedding of the steel belt in the tire can be determined by the separating cut.
This is a circuit board of a computer, consist of many different materials. The cut shows how fine on the board resistors, capacitors, etc. can be separated without pushing away.
This carbon pipe should be cut crosswise and at 45°.
These are profile strips from the automotive industry. The rubber-metal combinations must be separated in quality control and then checked on the contour side.
A tire and wheel manufacturer also presented separate versions of its products at the IAA motor show. In the case of the tire, you can clearly see the clean position of the metal mesh.
For testing purposes, this concrete cylinder had to be cut into slices. To improve the surface, the part was also turned during the sawing process.
This is the separating cut of the spark plug of a gasoline internal combustion engine. The spark plug consists of different materials.
