This is a rubber lip where the position and connection of the metal insert should be checked.
This special magnet, consisting of many different materials with different properties, should be separated to observe the microstructure.
This is a hardened steel ball with a diameter of 3 mm, such as those used in ball bearings. After the hardening process, the hardness test can be carried out more easily on the separated ball.
This is an electric motor with a strong magnetic core that had to be separated in the middle by the axle, the core and the two plain bearings.
This is a vehicle tire consisting of rubber compounds, nylon and steel, etc. The exact embedding of the steel belt in the tire can be determined by the separating cut.
This is a motor vehicle (car). A model vehicle, of course! However, it is also possible to cut through a real vehicle, but with an appropriate diamond wire saw.
This is a carbide insert which may be defective during manufacture. This can be checked after one or more fine cut-offs.
This is an underground cable made of copper, metal and rubber. After the fine separation cut, the exact arrangement of the individual strands can be determined after the production process.
This is a cut through an internal combustion engine. Among other things, the spark plug, pistons, connecting rods, roller bearings and housing were sawn through.
This is a coin (10 cents) that has been cut into three slices using two fine saw cuts. It should be noted that the coin must also be clamped (held). In this case with special wax on a ceramic disk.
This sensor was separated for presentation purposes at trade fairs.
These are profile strips from the automotive industry. The rubber-metal combinations must be separated in quality control and then checked on the contour side.
This involves the central separation of an expansion measuring screw.
A tire and wheel manufacturer also presented separate versions of its products at the IAA motor show. In the case of the tire, you can clearly see the clean position of the metal mesh.
This 30 kg heavy and 40 mm long lens with 16 optical lenses was separated for exhibition purposes.
Cutting the 3D printed parts from the carrier plate (SLM) can be carried out cleanly using a diamond wire cut. The cutting gap can be less than 0.5 mm.
This is the separating cut of the spark plug of a gasoline internal combustion engine. The spark plug consists of different materials.
